Terrain Workshop: (Clone) Trees 29

I'll be honest, this build is really only 1/3 Clone bricks.  This design came about due to digging through parts to find something similar to the 8x3 Leaf w/Bar from the Miniso Toys Lily.  I found eight pieces in the 2025 Brickcraft Poinsettia set that fit the profile.  A 6x4 Leaf w/Bar in Green and Red.

We start with four of those leaves attached to a Technic Pin Connector w/4 Clips.  Then you add four 1x1 Round Plates and three 1x1 Round Bricks.

I place the Round Plates on the top and bottom of the Pin Connector and

in between the Round Bricks.  That's a total of twelve pieces, which is 2

Hits.  It's 15 feet tall and up to 37.5 feet across -- depending on the angle

of the leaves -- in 6P Scale.

Having two sets of identical leaves in different colors allows you

to build Summer and Fall versions of these trees.  Or you could

just put them all on the table at the same time, Green on one side
and Red on the other to denote some sort of demarcation line.

There are also Dark Green versions of the 6x4 Leaf w/Bar if you

want a third color.  It's up to you how you want your table to look.

I hope this gives people ideas or techniques to use in their terrain builds.

Flickr page.